Search results
Results From The WOW.Com Content Network
NetBIOS over TCP/IP (NBT, or sometimes NetBT) is a networking protocol that allows legacy computer applications relying on the NetBIOS API to be used on modern TCP/IP networks. NetBIOS was developed in the early 1980s, targeting very small networks (about a dozen computers).
SRT provides connection and control, reliable transmission similar to TCP; however, it does so at the application layer, using UDP protocol as an underlying transport layer. It supports packet recovery while maintaining low latency (default: 120 ms). SRT also supports encryption using AES.
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for duplex, bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist.
Connection-oriented communication: [5] It is normally easier for an application to interpret a connection as a data stream rather than having to deal with the underlying connection-less models, such as the datagram model of the User Datagram Protocol (UDP) and of the Internet Protocol (IP).
The Dynamic Host Configuration Protocol (DHCP) is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
Eventually, the client will abort the connection due to an application layer timeout, but this may take a relatively long time. [3] TCP Cookie Transactions (TCPCT) standard was designed to overcome these shortcomings of SYN cookies and improve it on a couple of aspects. Unlike SYN cookies, TCPCT is a TCP extension and required support from both ...
When set the AVP Code belongs to the specific vendor code address space. The " M " bit, known as the Mandatory bit, indicates whether support of the AVP is required. If an AVP with the " M " bit set is received by a Diameter client, server, proxy, or translation agent and either the AVP or its value is unrecognized, the message must be rejected.